Are you struggling for the Cisco 642-901 exam? Good news,Just try Flydumps Cisco 642-901 exam dumps,it will help you a lot.In Flydumps new Cisco 642-901 vce or pdf braindump file,you can get all the Cisco 642-901 new questions and answers,we ensure high pass rate and money back guarantee.
Exam A
QUESTION 1
Which command should you issue first to configure EIGRP for IP?
A. ip eigrp routing
B. router eigrp process-id
C. ip eigrp autonomous-system-number
D. router eigrp autonomous-system-number
Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 2
Which two statements about 6to4 tunneling are accurate? (Choose two.)
A. Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates 6to4 tunneling.
B. Each 6to4 site receives a /48 prefix in a 6to4 tunnel.
C. 2002::/48 is the address range specifically assigned to 6to4.
D. Prepending 0x2002 with the IPv4 address creates an IPv6 address that is used in 6to4 tunneling.
E. 6to4 is a manual tunnel method.
Correct Answer: BD Section: (none) Explanation
Explanation/Reference:
QUESTION 3
Which statement is true about the implementation of IPv6 in an already existing IPv4 network?
A. IPv6 can be routed using the same routing protocol versions as IPv4
B. A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route them.
C. IPv4 and IPv6 networks can be routed simultaneously.
D. Only OSPF version 3 can be utilized for routing IPv4 and IPv6.
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 4
Refer to the exhibit. Will redistributed RIP routes from OSPF Area 2 be allowed in Area 1?
A. Because Area 1 is an NSSA, redistributed RIP routes will not be allowed.
B. Redistributed RIP routes will be allowed in Area 1 because they will be changed into type 5 LSAs in Area 0 and passed on into Area 1.
C. Because NSSA will discard type 7 LSAs, redistributed RIP routes will not be allowed in Area 1.
D. Redistributed RIP routes will be allowed in Area 1 because they will be changed into type 7 LSAs in Area 0 and passed on into Area 1.
E. RIP routes will be allowed in Area 1 only if they are first redistributed into EIGRP.
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 5
Refer to the exhibit. Router RTR is attempting to establish BGP neighbor relationships with routers RT1 and RT3. On the basis of the information that is presented in the exhibit, which two statements are true? (Choose two.)
A. RTR has a BGP password set but neighbor 10.0.0.1 does not.
B. RTR has a BGP password set but neighbor 10.0.0.5 does not.
C. RTR has a BGP password set but neighbor 10.0.0.1 has an incorrect password set.
D. RTR has a BGP password set but neighbor 10.0.0.5 has an incorrect password set.
E. Neighbor 10.0.0.1 has a BGP password set but RTR does not.
F. Neighbor 10.0.0.5 has a BGP password set but RTR does not.
Correct Answer: AD Section: (none) Explanation
Explanation/Reference:
QUESTION 6
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Which statement is true?
A. The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then the router will begin distributing addresses from pool 2.
B. The router will choose which pool to use based upon the interface the DHCP request was received on.
C. The configuration is invalid because the DHCP options are global configuration commands.
D. The configuration is incomplete until the DHCP pools are bound to the appropriate interface or interfaces.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 7
How is the designated querier elected in IGMPv2?
A. The first router to appear on a subnet is designated.
B. The host that responds first to the election query is designated.
C. The router with the lowest IP address on a subnet is designated.
D. The host with the lowest MAC address on a segment is designated.
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 8
A router is running BGP and receives more than one route for a particular prefix. Assume all the routes for this prefix have the same attributes. Which three path features would be reasons be for the router to ignore some of the routes and not consider them as candidates for the best path? (Choose three.)
A. paths that are marked as synchronized in the show ip bgp output
B. paths that are marked as not synchronized in the show ip bgp output
C. paths for which the NEXT_HOP is accessible
D. paths for which the NEXT_HOP is inaccessible
E. paths from an external BGP (eBGP) neighbor if the local autonomous system (AS) appears in the AS_PATH
F. paths from an internal BGP (iBGP) neighbor if the local autonomous system (AS) appears in the AS_PATH
Correct Answer: BDE Section: (none) Explanation
Explanation/Reference:
QUESTION 9
Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has been configured as a NSSA. Which statement is true about the NSSA Area 1?
A. Redistributed RIP and IGRP routes will appear in Area 1. They will be advertised via type 5 LSAs.
B. Only redistributed RIP routes will appear in Area 1. They will be advertised via type 7 LSAs.
C. Only redistributed IGRP routes will appear in Area 1. They will be advertised via type 7 LSAs.
D. No redistributed routes can appear in Area 1, only summary routes.
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 10
Refer to the exhibit. Switch Cat2 is receiving IGMP frames only on interface FastEthernet 0/3. Given IGMP snooping, out of which port or ports will switch Cat2 forward multicast traffic?
A. all ports
B. none of the ports
C. FastEthernet 0/3
D. FastEthernet 0/1, 0/2, 0/4
E. FastEthernet 0/1, 0/2, 0/3, 0/4
F. FastEthernet 0/1, 0/2, 0/4, 0/5, 0/6, 0/7, 0/8
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 11
An administrator types in the command router ospf 1 and receives the error message: “OSPF process 1 cannot start.” (Output is omitted.) What should be done to correctly set up OSPF?
A. Ensure that an interface has been configured with an IP address.
B. Ensure that an interface has been configured with an IP address and is up.
C. Ensure that IP classless is enabled.
D. Ensure that the interfaces can ping their directly connected neighbors.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 12
Refer to the exhibit. On the basis of the partial configuration, which two statements are correct? (Choose two.)
A. Only routes matching 10.0.1.0/24 will be advertised out Ethernet 0.
B. Only routes 10.0.1.0/24 will be sent out all interfaces.
C. Only routes 10.0.1.0/24 will be allowed in the routing table.
D. Only routes matching 10.0.0.0/8 will be advertised out Ethernet 0.
E. Only routes matching 10.0.0.0/8 will be advertised out interfaces other than Ethernet 0.
F. All routes will be advertised out interfaces other than Ethernet 0.
Correct Answer: AE Section: (none) Explanation
Explanation/Reference:
QUESTION 13
Which three statements about the EIGRP routing protocol are true? (Choose three.)
A. EIGRP sends periodic hello packets to the multicast IP address 224.0.0.9.
B. EIGRP sends periodic hello packets to the multicast IP address 224.0.0.10.
C. EIGRP supports five generic packet types, including hello, update, query, reply, and ACK packets.
D. EIGRP supports five generic packet types, including hello, database description (DBD), link-state request (LSR), link-state update (LSU), and LSAck.
E. EIGRP will form a neighbor relationship with another peer even when their K values are mismatched.
F. EIGRP will not form a neighbor relationship with another peer when their K values are mismatched.
Correct Answer: BCF Section: (none) Explanation
Explanation/Reference:
QUESTION 14
Refer to the exhibit. A network administrator has configured DHCP services on the router as shown. DHCP clients connected to the FastEthernet0/0 interface are working properly.
DHCP clients connected to the FastEthernet0/1 interface are not receiving addresses. Which two statements contain recommendations that will solve the problem? (Choose two.)
A. The ip helper-address 10.0.0.1 command should be issued so that the address can be added to the FastEthernet0/0 configuration.
B. The ip helper-address 10.0.0.1 command should be issued so that the address can be added to the FastEthernet0/1 configuration.
C. A second DHCP pool for network 10.10.0.0/24 should be configured.
D. The network shown in the output under the ip dhcp pool Central command should be changed to network
10.10.0.0 with a mask of 255.255.255.0.
E. An ip dhcp excluded-address global configuration command for network 10.10.0.0/24 should be issued.
Correct Answer: CE Section: (none) Explanation
Explanation/Reference:
QUESTION 15
Which two statements are true about the rendezvous point (RP) in a multicast network? (Choose two.)
A. An RP is required only in networks running Protocol Independent Multicast dense mode (PIM DM).
B. An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM).
C. An RP is required only in networks running Protocol Independent Multicast sparse-dense mode (PIM-SDM).
D. The multicast sources must register with the RP to form the multicast distribution tree.
E. The multicast receivers must register with the RP to form the multicast distribution tree.
F. To form the multicast distribution tree, the multicast sources register with and the receivers join the RP.
Correct Answer: BF Section: (none) Explanation
Explanation/Reference:
QUESTION 16
Refer to the exhibit. Given the output of a debug ip mrouting command, which two statements are true? (Choose two.)
A. This router received an IGMP host report from a group member or a PIM join message.
B. The reverse path forwarding (RPF) for the route 224.2.0.1 failed to find the interface on which the multicast packet was received.
C. Multicast route to 10.16.0.0/16 was added to the mroute table and created by a source directly connected to the router.
D. Multicast route to 224.69.15.0/24 was added to the mroute table and created by a source directly connected to the router.
E. The route to 224.69.15.0/24 will be out Ethernet 0.
Correct Answer: AC Section: (none) Explanation
Explanation/Reference:
QUESTION 17
Refer to the exhibit. On the basis of the information presented, which statement is true?
A. A default route is configured on the local router.
B. Network 6.0.0.0/8 was learned from an OSPF neighbor within the area.
C. OSPF router 5.0.0.2 is an ABR.
D. The default route is learned from an OSPF neighbor.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 18
Based on the topology shown in the network diagram, what optional EIGRP configurations will be required in order to achieve full connectivity within AS 100?
A. Use the EIGRP no auto-summary command on R1 and R2.
B. Use the EIGRP no auto-summary command on R3 and R4.
C. Use the passive interface on the R1 and R2 interface that connects to the 10.1.1.0/24 and 10.1.2.0/24 subnet respectively.
D. Use the passive interface command between the R3 and R1 connection and between the R3 and R2 connection.
E. Use the variance command on R3.
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 19
How is authentication handled with OSPFv3?
A. OSPFv3 for IPv6 authentication is supported by SHA-1 authentication.
B. OSPFv3 for IPv6 authentication is supported by MD5 authentication.
C. OSPFv3 for IPv6 authentication is supported by IPv6 IPsec.
D. OSPFv3 for IPv6 authentication is supported by IPv4 IPsec.
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 20
Which three IP multicast group concepts are true? (Choose three.)
A. If a packet is sent to a multicast group address, all members of the multicast group will receive it.
B. If a packet is sent to a multicast group address, the multicast frame contains the source multicast address.
C. A router does not have to be a member of a multicast group to receive multicast data.
D. A router does not have to be a member of a multicast group to send to the group.
E. A router must be a member of a multicast group to receive multicast data.
F. A router must be a member of a multicast group to send to the group.
Correct Answer: ADE Section: (none) Explanation
Explanation/Reference:
Cisco 642-901 tests containing questions that cover all sides of tested subjects that help our members to be prepared and keep high level of professionalism.The main purpose of Cisco 642-901 exam is to provide high quality test that can secure and verify knowledge, give overview of question types and complexity that can be represented on real exam certification