The Cisco 640-822 Questions & Answers covers all the knowledge points of the real exam. We update our product frequently so our customer can always have the latest version of Cisco 640-822.We provide our customers with the excellent 7×24 hours customer service. We have the most professional Cisco 640-822 expert team to back up our grate quality products. If you still cannot make your decision on purchasing our product, please try our Cisco 640-822 free pdf
Exam A
QUESTION 1
Refer to the exhibit. A network technician has added host A to the network. Host A cannot communicate on the network. A ping that is issued on the host to address 127.0.0.1 fails. What is the problem?
A. The router is not forwarding the ping packets to network 127.0.0.0.
B. The remote host at 127.0.0.1 is unreachable.
C. The default gateway is incorrect.
D. The IP address of host A is incorrect.
E. The TCP/IP protocols are not loaded.
Correct Answer: E Section: (none)Explanation
Explanation/Reference:
QUESTION 2
Refer to the exhibit. A network technician is attempting to use HyperTerminal to configure a new router using the settings shown. What is the reason the technician is unable to connect to the router?
Certkey.com-Make You Succeed To Pass IT Exams Certkey 640-822
A. The bits per second should be set to 9600.
B. The data bits should be set to 6.
C. Parity should be set to mark.
D. The stop bits should be set to 2.
E. Flow control should be set to hardware.
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 3
Refer to the exhibit. What could be possible causes for the “Serial0/0 is down” interface status? (Choose two.)
A. A Layer 1 problem exists.
B. The bandwidth is set too low. Certkey.com-Make You Succeed To Pass IT Exams Certkey 640-822
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0/0 interface.
Correct Answer: AD Section: (none) Explanation
Explanation/Reference:
QUESTION 4
Which line from the output of the show ip interface command indicates that there is a Layer 1 problem?
A. Serial0/1 is up, line protocol is up
B. Serial0/1 is up, line protocol is down
C. Serial0/1 is down, line protocol is down
D. Serial0/1 is administratively down, line protocol is down
Correct Answer: C Section: (none)Explanation
Explanation/Reference:
QUESTION 5
Refer to the exhibit. Workstation A must be able to telnet to switch SW-A through router RTA for management purposes. What must be configured for this connection to be successful?
A. VLAN 1 on RTA
B. default gateway on SW-A
C. IP routing on SW-A
D. cross-over cable connecting SW-A and RTA
Correct Answer: B Section: (none)Explanation
Explanation/Reference:
QUESTION 6
Refer to the exhibit. Two buildings on the San Jose campus of a small company must be connected to use Ethernet with a bandwidth of at least 100 Mbps. The company is concerned about possible problems from voltage potential differences between the two buildings. Which media type should be used for the connection?
Certkey.com-Make You Succeed To Pass IT Exams Certkey 640-822
A. UTP cable
B. STP cable
C. coaxial cable
D. fiber optic cable
Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 7
What are two advantages of Layer 2 Ethernet switches over hubs? (Choose two.)
A. decreasing the number of collision domains
B. filtering frames based on MAC addresses
C. allowing simultaneous frame transmissions
D. increasing the size of broadcast domains
E. increasing the maximum length of UTP cabling between devices
Correct Answer: BC Section: (none) Explanation
Explanation/Reference:
QUESTION 8
Refer to the exhibit. A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?
Certkey.com-Make You Succeed To Pass IT Exams Certkey 640-822
A. Change the first line to interface fastethernet 0/1.
B. Change the first line to interface vlan 0/1.
C. Change the fifth line to ip default-gateway 192.168.17.241.
D. Change the fifth line to ip route 0.0.0.0 0.0.0.0 192.168.17.1.
E. Change the sixth line to line con 0.
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
Cisco 640-822 tests containing questions that cover all sides of tested subjects that help our members to be prepared and keep high level of professionalism. The main purpose of Cisco 640-822 exam is to provide high quality test that can secure and verify knowledge, give overview of question types and complexity that can be represented on real exam certification
QUESTION 9
Refer to the exhibit. Pierre has just installed the mail server and Switch2. For security reasons UDP packets are not permitted outbound on the Fa0/1 router interface. Pierre is now at his workstation testing the new installation and is not able to establish SMTP communication to the mail server.
What is the most likely cause for lack of communication between Pierre’s workstation and the mail server? Certkey.com-Make You Succeed To Pass IT Exams
Certkey 640-822
A. The crossover cable should be a straight-through cable.
B. UDP is blocked coming out of the Fa0/1 interface on the router.
C. The server should be directly connected to the router.
D. The IP addresses are all on the same network. No router is required.
Correct Answer: A Section: (none)Explanation
Explanation/Reference:
Well-regarded for its level of detail, assessment features, and challenging review questions and hands-on exercises, Cisco 640-822 helps you master the concepts and techniques that will enable you to succeed on the Cisco 640-822 exam the first time.