Cisco 642-176 contains a powerful new testing engine that allows you to focus on individual topic areas or take complete, timed exams from Cisco 642-176.The assessment engine also tracks your performance and presents feedback on a module-by-module basis, providing question-by-question Cisco 642-176 to the text and laying out a complete study plan for review.Cisco 642-176 also includes a wealth of hands-on practice exercises and a copy of the Cisco 642-176 network simulation software that allows you to practice your Cisco 642-176 hands-on skills in a virtual lab environment.The Cisco 642-176 supporting website keeps you fully informed of any exam changes
Exam A
QUESTION 1
Refer to the exhibit. What are the two options available when using the Security Audit configuration task in Cisco SDM? (Choose two.)
A. Perform a virus scan.
B. Perform a secure audit on the router.
C. Perform a one-step lockdown on the router.
D. Perform a denial-of-service attack on the router to verify that it is protected.
E. Perform a real-time inspection of incoming traffic destined for the router.
Correct Answer: BC Section: (none) Explanation
Explanation/Reference:
QUESTION 2
The recommended WAN access method for a simplified and cost-effective Cisco Single-Site Secure Network Foundation deployment provides which type of service?
A. best-effort
B. low latency
C. guaranteed quality
D. guaranteed bandwidth
Correct Answer: A Section: (none) Explanation Explanation/Reference:
QUESTION 3
Refer to the exhibit. From this Cisco SDM Security Audit Wizard screen, what should you do to secure the router?
A. Click Next.
B. Click Fix All, then Next.
C. Click Fix All, then clear CDP check box, then Next.
D. Click Fix All, then clear CDP check box, then Next, then immediately reboot the router.
E. Click Fix All, then clear CDP check box, then Next, then manually disable CDP on the WAN interface.
F. Click Fix All, then clear CDP check box, then Next, then manually disable CDP on the WAN interface, then immediately reboot the router.
Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 4
Refer to the exhibit. In a Cisco Single-Site Secure Network Foundation implementation, which factor affects your choice of switch configuration?
A. type of QoS scheme that is being used
B. maximum number of supported IP phones
C. maximum amount of packet latency acceptable
D. type of security scheme that is being implemented
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 5
What is the reason for running spanning tree in a Cisco Single-Site Secure Network Foundation solution?
A. to allow management of all network devices
B. to aggregate logical network groups together at one central point
C. to protect the network in case someone inadvertently creates a physical loop in it
D. to ensure that if a device fails another device will automatically take over for it
E. to connect like devices, such as phones or computers, in logical network groups
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 6
Refer to the exhibit. Which Cisco SDM configuration task would you select to configure a static route to the service provider?
A. NAC
B. NAT
C. Routing
D. Quality of Service
E. Intrusion Protection
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 7
Which statement correctly describes network security settings in Cisco Network Assistant for the Catalyst Express 500 switch?
A. The default network security setting is “HIGH”.
B. The “LOW” setting enables broadcast storm control and limits the number of devices that can connect to a switch port.
C. The “LOW” setting disables broadcast storm control and has no effect on the number of devices that can connect to a switch port.
D. The “LOW” setting enables broadcast storm control, but has no effect on the number of devices that can connect to a switch port.
E. The “LOW” setting disables broadcast storm control but limits the number of devices that can connect to a switch port.
Correct Answer: B Section: (none) Explanation
Explanation/Reference: QUESTION 8
Refer to the exhibit. The exhibit is an example of which technology being implemented?
A. PAT
B. QoS
C. 802.1Q
D. VLANs
E. spanning tree
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 9
Which three of these are prerequisites for resetting a Catalyst Express 500 switch when Cisco Network Assistant is unavailable? (Choose three.)
A. a switch with no connected devices
B. physical access to the switch
C. a PC pre-configured with a specific IP address and mask
D. at least one enabled switch port that is unconnected to any device
E. a PC or laptop with Windows 2000 or Windows XP installed and a web browser that has JavaScript enabled
Correct Answer: BDE Section: (none) Explanation
Explanation/Reference: QUESTION 10
If voice and data traffic will be sent and received via a WAN link, what must be configured to provide a certain amount of dedicated bandwidth and to prioritize the voice traffic over other types of network traffic?
A. IPSec VPN
B. NAT
C. QoS mechanisms
D. EIGRP routing protocol
E. Static routing
F. Firewall
Correct Answer: C Section: (none) Explanation
Explanation/Reference: